1. If you have GB and G4 satellites programmed into your receiver, move your dish to GB-601, verify that you are receiving a good , clear picture of Bloomberg, push Option 5 on your remote control, write down the dish position and skew settings for that satellite. Then push Exit, or View to remove that menu from the tv screen. Move you dish to G4-16, verify that you are getting a good, clear picture on Shepherd’s Chapel, push Option 5, write down the dish position and skew settings for that satellite.
2. Subtract the dish position for GB from the dish position of G4. Divide the difference by two and then add the result to the GB dish position. If you calculated correctly, that resulting number should be half-way between the numbers for GB and G4 and will be the proper dish position number for setting G3.
3. Press Option 6, 4, 4, use your arrow keys on your remote control to highlight G3, press Enter. If your screen then says “Change settings”, hit Enter again on your remote control. You should now have the main satellite Programming screen on your tv set. Use your down arrow to highlight the dish position number in yellow. Use your left or right arrow keys on your remote control to change the dish position to the number that you calculated in step #2 above.
4. Look at the skew settings if they are listed on the tuning screen, make sure they are set the same as GB and G4 were set. for H and V.
5. Push the GO BACK button on your remote control and you should see a small pop-up screen on your tv saying Save setting for G3. Push ENTER and G3 will then be programmed at the position you have selected. Press EXIT, or VIEW, or GO BACK four times to get out of the satellite programming menu.
6. Your dish should now be pointing at G3 satellite. Select a channel that you have programming on, like 500 for CNBC, and the channel should come on your screen.
7. If your receiver does not recognize that there are any digital channels like 500 on G3, then your 4DTV needs to be remapped.
8. To remap a model 922 receiver, move your dish to G1-03, or G1-150, make sure you have a green DC light, turn off the power to your 4DTV, unplug it from the electricity for only 30 seconds., plug it back in and wait approx. 60 minutes before turning the 4DTV back on. The new channels should then be mapped into the memory of your 4DTV. If you then move to G3 and select channel 500, your receiver should have CNBC if you have a subscription to that service.
PLEASE NOTE: OMEGASOURCE IS NOT RESPONSIBLE FOR ANY DAMAGE TO EQUIPMENT CAUSED BY USING THESE INSTRUCTIONS.
